THERMOPLASTIC (PE) SEMI-MASK FOR 2 M6000 FILTERS SOLD SEPARATELY

Descriptive:

Half mask in thermoplastic elastomer. Elastic straps. Prepared for 2 series filters M6000, sold separately.

Materials:

Semimaschara TPE elastic bands.

Strengths:

Attack filters bayonet Exhalation valve. Elastic adjustment system.

Instructions for use:

Half mask for respiratory protection against dust, fumes and gases. It is recommended to wear a mask when exiting the work area contaminated and this until completely eliminated residual contaminant from the clothes.

Limitations of use:

Do not use outside the scope specified above. Do not use the mask in an environment poor
oxygen (<19% of the volume of air) or in a too oxygen-rich (> 25% of the volume of air). Do not use the
half mask to extinguish the fire, throw sand or to protect against contaminants not specified in the instructions
of the filters. Does not protect or eyes, or skin against vapors or gases likely to burn or irritate the skin, in the case of
absorption or penetration. The spectacles,, beard or other facial hairiness are likely to prevent
effective adaptation of the half-mask on the face.

Instructions for storage:

The storage of the filters must be done in a clean, away from heat and sunlight. The filters must be
stored at a temperature between -5 ° C and + 35 ° C with a maximum relative humidity of 75%. If the filters are not
stored in its original packaging or if they are not stored at the recommended conditions, the expiration date printed
on the filter can no longer be valid.

Instructions for cleaning / maintenance:

Clean all parts with soap and water and disinfect the inside of the mask with an antiseptic solution. Do Not
use solvent-based, petroleum, chlorinated or organic. Rinse with clean water. Dry to eliminate
excess water. Check that the valves are not damaged. If they were damaged, you have to change the
mask. Perform a test of resistance. Do not clean the cartridges.

Performance:

Complies with the requirements of the European Directive 89/686, in particular in terms of ergonomics, safety, comfort, and to EN140: 1998.