Half mask rubber supplied with 2 Fitri A2 P3. Elastic straps. Packed in plastic preformed.

Descriptive:

Half mask rubber supplied with 2 Fitri A2 P3. Elastic straps. Packed in plastic preformed.

Materials:

Semimaschara rubber hypoallergenic. Elastic bands. Plastic shell and charcoal.

Strengths:

Protects the airways from dust, vapors and gases. Rubber odorless and non-allergenic. Exhalation valve. Elastic adjustment system.

Instructions for use:

Half mask with 2 filters A2 and 2 pre-P3 filters for respiratory protection against dust, gases and organic vapors when the point diebollizione is higher than 65 ° C and against solid aerosols and / or toxic liquids. It is recommended to wear a mask when exiting the work area contaminated and this until complete elimination of residual contaminants from the clothes. Absorbency: average. Replace if present, an increase of resistance to
breathing or if any odor is perceived by the user. Check that the data on the type of filter match the intended use.

Limitations of use:

Do not use outside the scope specified above. Do not use the mask in an environment of low oxygen (<19% of the volume of air) or in a too oxygen-rich (> 25% of the volume of air). Do not use the mask to extinguish the fire, throw sand or to protect against contaminants not specified in the instructions for use of filters. Does not protect or eyes, or skin against vapors or gases likely to burn or irritate the skin, in the case of absorption or penetration. The spectacles,, beard or other facial hairiness are likely to impede effective adaptation of the half-mask on the face.

Instructions for storage:

Store in its original packaging protected from light and contaminants, in a hygienic place, dry and cool.

Instructions for cleaning / maintenance:

For a thorough cleaning of the half mask, remove the filter and exhalation valve, clean the body of the half mask with warm water and soap, dry. Do not use solvents, strong detergents, petroleum-based products or thinner to clean the half mask or worse valves in gomma.Dopo each use broken or not, the mask must be clean, worn or damaged parts verified. The state of the valves should be checked once a week. Change the filter and the valves in case of visual impairment.

Performance:

Complies with the requirements of the European Directive 89/686, in particular in terms of ergonomics, safety, comfort, to EN140: 1998, the standard EN14387: 2004 (A2) and the standard EN143: 2000 / A1: 2006 (Class P3 R).