Kit of two filters A1 medium capacity for semi-mask M6100-M6200-et JUPITER & JUPITER.

Descriptive:

Kit of two filters A1 medium capacity for semi-mask M6100-M6200-et JUPITER & JUPITER.

Materials:

Plastic shell and charcoal.

Instructions for use:

Filter medium capacity (for a gas content between 0.1% and 0.5% by volume), can protect against organic gases and vapors with a boiling point above 65 ° C. Replace in the present case an increase of resistance to breathing or if any odor is perceived by the user. Check that the data on the type of filter match the intended use.

Limitations of use:

Do not use a filter whose packaging is damaged;
Do not alter or modify the facial part or filters, it will decrease the protective factor of the device;
Do not use this apparatus in tight spaces or closed (reservoirs, tunnels), or in the spaces where the concentration of contaminants would be too high;
Do not use in places where the oxygen concentration is lower than 19.5%;
The use of filters and semi-masks is limited by the concentration of contaminants, see norm EN529: 2006 (Recommandazioni for selection, use, maintenance et care) and VME the same (see the table of risks) ;
Do not use this tool for respiratory protection in potentially explosive atmospheres or oxygen enriched;
This device does not ensure protection against dioxide (CO2) and carbon monoxide (CO).
Do not use this device in areas where the concentration of contaminants is not known or is likely to be immediately dangerous to the health of those who use it.

IMMEDIATELY LEAVE THE AREA OF WORK:

a) if there is an emergency;
b) At the time of using a filter against particles or combined, when breathing becomes difficult and can saturate the filter must be replaced in an area without risk;
c) At the time of using a filter against gas or combined, you feel you can feel the contamination or if you experience irritation. Your filter can be saturated and must be replaced in an area not at risk;
d) If you feel tired, if you experience dizziness or other uncomfortable sensations;
e) if the mask is damaged.

WARNINGS:
Wearing a beard or something that does not fit in the face mask, can reduce the protective efficacy of the device.

Instructions for storage:

The storage of ½ mask must be done in an appropriate place to protect it from dust, away from extreme cold or high sunlight, excessive humidity or chemicals.
The filters must be stored at a temperature between -5 ° C and + 35 ° C with a maximum relative humidity of 75%. If the filters are not stored in their original packaging or if they are not stored at the recommended conditions, the expiration date printed on the filter can not be more valid.

Instructions for cleaning / maintenance:

Clean all parts with soap and water and disinfect the inside of the mask with an antiseptic solution. Do not use solvent-based, petroleum, chlorinated or organic. Rinse with clean water. Dry to eliminate
excess water. Check that the valves are not damaged. If they were damaged, you have to change the mask. Perform a test of resistance. Do not clean the cartridges.

Performance:

Complies with the requirements of the European Directive 89/686, in particular in terms of ergonomics, safety, comfort, and the standard EN14387: 2004 + A1: 2008